The thrill round ExpressLRS Gemini Mode is simple, but there’s an absence of true range receivers available on the market that help this superior characteristic. Enter the RadioMaster RP4TD – marking a big improve from its predecessor, the RP3, which solely provided antenna range. Let’s dive in to see what it presents.
Study extra about ExpressLRS in our complete tutorial: https://oscarliang.com/setup-expresslrs-2-4ghz/
What’s Gemini Mode? https://oscarliang.com/expresslrs-gemini/
The place to Purchase?
Get the RP4TD Receiver from these distributors:
The package deal features a set of silicone wires for connecting to the flight controller, and three items of clear warmth shrink, enhancing the sturdiness of the setup.
Technical Specs
- MCU: ESP32
- RF Chip: Twin SX1281
- Antenna: Twin 65mm 2.4GHz T Antennas
- Frequency Vary: 2.4GHz
- Most Refresh Fee: 500Hz / F1000Hz
- Telemetry RF Energy: Max 100mW (x2)
- Working Voltage: DC 4.5-12.0V
- Weight: 1.4g (excluding antennas)
- Dimensions: 23.7×16.3×4.0mm
- Pre-installed Firmware: ExpressLRS V3.3.0
- Firmware Goal: RadioMaster RP4TD 2400 RX
- Bus Interface: CRSF
- Prolong Interface: UART
The standout characteristic of the RP4TD is its two separate SX1281 RF chips and TCXO (Temperature Compensated Crystal Oscillators). This design means the receiver is best geared up to deal with a variety of temperatures and difficult environments. With twin RF chips, the RP4TD presents two telemetry outputs at 100mW every, a big improve for lengthy vary flying. For these trying to push the boundaries of two.4GHz FPV flying, this receiver looks like a super selection.
Construct High quality
The receiver itself is compact and well-built.
The highest facet includes a boot button and two U.FL connectors for the antennas. The 4 soldering pads are accessible on either side of the receiver with clear labels: 5V, GND, RX and TX.
Though the RP4TD is notably bigger than single-antenna EP1 receivers on account of its twin RF chains, the design stays impressively compact.
Nonetheless, the inclusion of longer antennas may have enhanced its enchantment for bigger builds, similar to 7″ or 10″ drones. Nonetheless, prolonged antenna wires are available for these in want:
95mm / 120mm / 240mm antenna:
Set up
Putting in the RP4TD is as simple as any ExpressLRS receiver. The secret’s to make sure optimum antenna placement. To make sure one of the best reception, positioning the antennas to keep away from getting blocked simultaneous by any a part of the quadcopter is essential. This separation is important for sustaining a constant and dependable connection.
Conclusion: Is the RP4TD Proper for You?
Observe that true range doesn’t vital improve vary however supposed to boosts reliability and hyperlink high quality, notably with Gemini mode enabled.
The RadioMaster RP4TD Range ELRS Receiver is a big improve for FPV pilots searching for the utmost in reliability and efficiency. Its dual-chip design and strong construct make it a best choice for demanding flight circumstances.
Get the RP4TD Receiver from these distributors:
For these constructing bigger drones, think about getting some longer antennas for one of the best setup. For individuals who push their FPV flying to the extremes, the RP4TD is a worthy funding, guaranteeing that your drone stays in fixed, dependable communication together with your transmitter.
95mm / 120mm / 240mm antenna: